Meridian SEED EXPRESS Bulk Seed Tender Operator's Manual page 25

Operator's Manual: 240 FF Basic Seed Express
Hydraulic Oil Flow Control Valve:
This valve regulates the flow of hydraulic oil to
conveyor belt motor.
To adjust the speed, loosen the knob, then move
the lever in the desired direction.
• Move lever toward zero (0) for a slower speed.
• Move toward ten (10) for a higher speed.
Tighten the knob to hold the lever in place.
Conveyor Tube Discharge:
The hydraulic motor for the 8 inch conveyor belt
is located at the discharge.
• A telescoping delivery spout is connected to
the discharge.
Conveyor Belt On/Off Switch:
This toggle switch is located on the telescoping
delivery spout. It controls the hydraulic motor to
the conveyor belt.
Note:
The switch and wiring harness
can be moved to a more
convenient location.
Compartment Slide Gates:
Use the push/pull levers, at the rear, to open and
close the compartment gates.
• Adjustable slide gate stops must be moved
out of the way to operate the levers.
• Return the stops to their original location to
keep slide gates closed.
Compartment Ladder:
The ladder is located on the right-side of the
tender. Keep the ladder rungs clean to prevent a
slipping hazard.
Revised 01.2022
Bulk Seed Tender
™ ®
Fig 11 - Hydraulic oil flow control valve
Fig 12 - Conveyor discharge
Fig 13 - Switch on telescoping delivery spout
Fig 14 - Compartment slide gate levers
®
3-5