Every 100 Hours Or Monthly; Every 200 Hours Or Annually - Meridian SEED EXPRESS Bulk Seed Tender Operator's Manual

Operator's Manual: 240 FF Basic Seed Express

4.2.3 Every 100 Hours or Monthly:

13. Grease conveyor belt roller bearings.
14. Grease the hydraulic cylinder.
15. Check wheel nuts.
- Torque to 90-120 ft-lb
16. Adjust the trailer brakes.
17. Inspect tires for wear.
18. Grease the axles.
19. Inspect brake magnets for wear.
20. Inspect suspension parts for wear.
21. Check battery electrolyte levels, and clean
terminals to remove dirt and corrosion.

4.2.4 Every 200 Hours or Annually:

22. Change the engine oil.
23. Check hydraulic oil for contaminants.
24. Check hydraulic hoses and fittings for wear.
25. Check that battery retains maximum charge.
26. Inspect brake lining wear:
- Check brake cylinder for leaks.
- Inspect brake wiring for damage.
27. Repack the wheel bearings:
- Check for excessive play in the bearings.
- Grease the wheel bearings.
28. Check the wheel hub for wear.
29. Inspect axle grease seal for leakage.
30. Inspect springs for any wear or loss of arch.
4-4
Bulk Seed Tender
™ ®
31. Inspect all electrical wiring connections for
looseness or corrosion.
- Tighten and/or seal, as necessary.
32. Check trailer axle, frame, hitch and tender
hold-down bolts.
- Refer to Section 6.2 Bolt Torque.
33. Thoroughly clean the tender.
- Wash to remove all dirt, mud, debris and
residue.
- Wash around and inside the intake hopper
and chutes.
- Clean inside the conveyor tube, and belt.
Fig 39 - Discharge roller bearing
Fig 38 - Trailer wheels
Revised 01.2022
®