Step 4A - Ethernet Device Discovery - Datalogic Matrix 120 Product Reference Manual

RAPID CONFIGURATION

Step 4A - Ethernet Device Discovery

The following configuration procedure assumes that a laptop computer running
DL.CODE is connected to a factory default reader through the Ethernet port. See Step 1 -
Connect the System.
The User Interface opens and displays a list of all the devices belonging to the Local Area
Network. DL.CODE has a discovery feature to accomplish this task.
The discovery feature will also show devices not belonging to the LAN and display them
in gray (see Figure 10).
1. First the device must be added to the LAN by aligning its IP Address to the net-
2. Find your device in the list by matching its serial number (SN) then click on the
3. Change the Ethernet Settings (IP Address, Subnet Mask, Gateway Address etc.)
10 MATRIX 120™
a. All devices can be configured through their Main Serial port. However, through
this interface, configuration is slower than the Ethernet or USB interfaces and
presents some limitations. It is recommended to use the Serial interface for
configuration only if the other interfaces are not available.
work. The network administrator should provide valid LAN address(es).
device wrench icon to open the Device Environment Configuration window.
according to the network requirements.
Figure 10 - Device Discovery