Table of Contents
Advertisement
Available languages
Available languages
8980773
a.
Never remove the grounding prong or modify the plug in any
way, as this will render the tool unsafe.
b.
Do not use any adapter plugs.
WARNING! All wiring should be performed by a qualified electrician.
POWER CORD
1.
Insert the power cord plug directly to the power supply whenever
possible. Use extension cords or surge protectors only when the
tool's power cord cannot reach a power supply from the work area.
2.
Do not operate this tool if the power cord is frayed, damaged or
poorly spliced, as an electric shock may occur, resulting in personal
injury or property damage.
a.
Inspect the tool's power cord for cracks, fraying or other faults in
the insulation or plug before each use.
b.
Discontinue use if a power cord feels more than comfortably
warm while operating the tool.
3.
Keep all connections dry and off the ground to reduce the risk of
electric shock. Do not touch the plug with wet hands.
4.
Prevent damage to the power cord by observing the following:
a.
Do not pull on the cord to disconnect the plug from an outlet.
b.
Keep the cord away from heat, oil, sharp edges or moving parts.
c.
Never use the cord to carry the tool.
d.
Place the electrical cord in a position that prevents it from
coming into contact with the tool and getting caught by the
workpiece. The cord should always stay behind the tool.
5.
Do not allow people, mobile equipment or vehicles to pass over
unprotected power cords.
a.
Position power cords away from traffic areas.
b.
Place cords in reinforced conduits or place planks on either side
of the power cord to create a protective trench.
6.
Do not wrap the cord around the tool, as sharp edges may cut
insulation or cause cracks if wound too tight. Gently coil cord and
either hang on a hook or fasten with a device to keep cord together
during storage.
6
Metal Vibratory Tumbler
For technical questions call 1-800-665-8685
V1.0
Advertisement
Table of Contents
