Cleaning And Maintenance Of The Dispensing System; Peak-Load Negotiation - Miele PW 6241 Operating And Installation Instructions

Dispenser calibration
V:
100 ml
Press the multifunction button

Stop the pump by pressing the
automatically after 60 seconds.
Measure the required amount in the measuring vessel.

Dispenser calibration
V: 100 ml
Enter the amount measured in the

P
The throughput is calculated in
Press the  "Save" function button.

The measured value is assigned to the pump.
Reattach the hose.


Cleaning and maintenance of the dispensing system

Rinse the dispensing system through with hot water every 2 weeks,
or before shutting the dispenser pumps down for any length of time,
to avoid the system getting clogged up and corroded.
Also rinse out the siphons with water.

Put the siphons in a container of warm water (40-50 °C).

Use dispenser calibration to activate each pump until the dispens-

ing system is rinsed through.
Check the connection points, hoses, dispensing sockets and wash-

ers for leaks.

Peak-load negotiation

When the peak-load function is activated, the heating is deactivated
and the programme stopped.
Activate the peak-load function.

The following message appears in the display:
1
Cottons
Prog. stopped. Peak load cut-out.
Programme will continue automatically.

Dispenser pump 1

t: s P: No
0

0/1
0/1
.
0/1
button, or the pump will stop
Dispenser pump 1

t: s P: 200,0 ml min
30
0/1

V:
field.
ml/min
Optional modules

/

by the controls.

41