Timing the First and Second
Place Finishers
1.
Enter the Stopwatch Mode.
Navigating Between Modes
l
2.
Use the operations below to measure
elapsed time.
D
Start
A
1st Finisher*
D
2nd Finisher*
* The display alternates between the time
of the first place finisher and [SPL].
Elapsed time is shown in 1/100-second
●
units for the first hour of the
measurement. After the first hour,
elapsed time is shown in one-second
units.
First hour
After first hour
Minutes, seconds
Hours, minutes
1/100 seconds
3.
Press (A) to display the time of the second
finisher.
4.
Press (A) to reset the measurement time
to all zeros.
Watch Operation Guide 5690
The timer counts down from a start time
specified by you. A beeper sounds when the
end of the countdown is reached.
The beeper will not sound if the battery is
●
low.
Using CASIO WATCHES to
Configure Timer Settings
If the watch is paired with a phone, you can
also use the CASIO WATCHES phone app to
set the timer start time.
Configuring Watch Settings
l
Seconds
Setting the Countdown Start
Time
The countdown start time can be set in 1-
second units up to 24 hours.
If a timer countdown operation is in
●
progress, reset the timer to its current start
time before performing this operation.
Using the Timer
l
1.
Enter the Timer Mode.
Navigating Between Modes
l
2.
Hold down (A) for at least two seconds.
Release the button when the hour setting
starts to flash.
This is the setting mode. The hands
●
automatically shift out of the way for
easy viewing of the display and other
indicators.
Timer
Hours
3.
Use (B) and (D) to change the timer hours
setting.
Holding down (B) or (D) scrolls through
●
settings at high speed.
4.
Press (C).
This causes the minutes digits to flash.
Minutes
5.
Use (B) and (D) to change the minutes
setting.
6.
Press (C).
This causes the seconds digits to flash.
Seconds
7.
Use (B) and (D) to change the seconds
setting.
8.
Press (A) to exit the setting screen.
Note
Setting a start time of [0:00 00] will
●
perform a countdown of 24 hours.
While the setting is being configured,
●
the watch will exit the setting operation
automatically after about two or three
minutes of non-operation.
20