Table of Contents
Advertisement
User manual
5. Mounting the
To avoid any damage on the tonearm or turntable, we recommend that two people do the assembly.
Pic. 6: Placing the tonearm chassis on the spacer discs
Pic. 7: Tightening the mounting bolts
Please note:
You may need to readjust the levelling of the turntable once you have fully completed set-up of the
TT1 MI
tonearm.
Made in Germany
TT1 MI
tonearm
Place the tonearm chassis on top of the two spacer
discs. Lift it carefully, making sure that the sliding
tonearm bridge is positioned to the rear of both
sliding bases as shown in picture 6.
While holding it in place insert the two large hex
socket headed bolts provided (see page 4 package
content No. 4) and tighten them (see picture 7).
Please note: Always hold the tonearm in place,
while tightening the mounting bolts.
Move the tonearm several times back and forth to
align the base plates.
Then you can fix the tonearm finally with the
screws.
Finally check the ease of movement of the tonearm
again by moving it back and forth several times.
You may have to repeat the process.
Page 9
Advertisement
Table of Contents
