Undo/Redo Erase; Track Exchange; Executing Track Exchange - Fostex VF160EX Operation Manual

4. Press the [ENTER/YES] key.
"Sure?" flashes.
5. Press the [ENTER/YES] key once again.
The erase process will takes place. "Wait Erasing!" flashes
on the display while data is being erased. "Completed!"
lights up on the display when the data is successfully erased.
6. Press the [EXIT/NO] key (or [STOP] key).
The LCD returns to the Normal Display prior to the editing
mode.
<Remember!>
To erase all data between ABS 0 and REC END, it is
recommended that the time after REC END is set as the
ERASE end point (AUTO PUNCH OUT point) to ensure
that all the data is completely erased. In such case, move
the current location of the recorder to the REC END point
prior to setting the AUTO PUNCH OUT point and then
press the [PLAY] key from that REC END point to move
the REC END point slightly forward. Then press STOP.
By setting that STOP point (time) to the [AUTO PUNCH
OUT] key, it becomes possible to thoroughly erase all data
from that section. The hard disk does not access any
point after the REC END point, even when PLAY is started.
When there is no data on that section, only the time will
be counted.
"Track Exchange" allows the tracks currently on the program to be interchanged (all real tracks and additional tracks)
on mono track or multiple track (2 tracks or 8 tracks each) units.
This function makes it possible to exchange real tracks. A real track can be emptied by moving a real track to a blank
additional track. This means that real track can be recorded with other data. All-in-all, track exchange allows effective
utilization of the tracks.
As already described in the "Erase" section, the "Track Exchange" feature is necessary to check the REC END point
of an additional track.
One track exchange
Track 1 Track 9
Track 2 Track 10
Track 3 Track 11
Track 4 Track 12
Track 5 Track 13
Track 6 Track 14
Track 7 Track 15
Track 8 Track 16
2 track block exchange
8 track block exchange

UNDO/REDO Erase

The erase procedure can be undone and redone with
the UNDO/REDO feature.
* Data eased can be undone (unerased) by pressing the
[UNDO/REDO] key after ERASE. The data will return to the
pre-erase status.
* The data erased but undone (unerased) can be redone
(re-erased) by pressing the [UNDO/REDO] key immediately
after undoing the erase process. The data will return to the
post-erase status.
Note the following when executing the UNDO/REDO
feature.

Track Exchange

Executing Track Exchange

1. Press the [EDIT] key while the recorder is in the STOP
state, and show "Track Exchange?" on the display.
Track 17
Track 18
Track 19
Track 20
Track 21
Track 22
Track 23
2. Next press the [ENTER/YES] key.
Track 24
The track exchange selection display appears.
The current display indicates that track 1-8 and track 9-
16 can be exchanged in 8 track units.
To select another combination, go to the next step,
respectively.
76
<Precautions>
The UNDO/REDO feature is valid only when the
recorder is in the STOP state.
UNDO/REDO is no longer possible if the following
procedures take place after ERASE.
1. When data is newly recorded.
2. When data is newly edited.
3. When the AUTO PUNCH mode is ON and PLAY (or
RECORD) mode is effected, and the point has already
passed the AUTO PUNCH IN point.
4. When the power is turned OFF.
5. When program selection takes place.
Flashing