Starting Recording; Playing Back The Recorded Track; Undoing Recording (Undo/Redo) - Fostex MR16 Owner's Manual

MR16
Owner's Manual (Basic operations)
4) Set track fader 1 and [MASTER] fader to the
nominal position (marked by
Raising these faders allows you to monitor the
input sound. If these faders are not raised, you
cannot monitor the sound via headphones.
<Note>: The fader for track 1 is used to ad-
just the monitor level. To adjust the record-
ing level, use the [ TRIM ] control of the [ IN-
PUT A ] channel.
5) Press the [RECORD] key once (the key indicator
starts flashing).
Track 1 (which is record armed) now enters
the input monitor mode and "
the home screen.
6) While playing the guitar, adjust the recording level
using the [TRIM] control of the [INPUT A]
channel.
Adjust the level appropriately so that the PEAK
indicator does not light.
Turning the [PHONES VOL] control clockwise
raises the headphone monitor level.
The screen shows the input level of track 1, as
well as the stereo L and R output levels.
<Note>: Adjust the [ TRIM ] control properly
so that the PEAK indicator does not light at
the loudest part of the guitar sound. If the
input level is too high, the PEAK indicator
lights and the sound may be distorted or
noisy.
<Tip>: When receiving a line level signal, set
the [TRIM] control to left ("LINE") to get the
appropriate level. When receiving a micro-
phone signal, set the [TRIM] control to right
("MIC") to get the appropriate level.
).
7)
8)
" is shown on
9)
10)
If you press the [UNDO/REDO] key after finishing
recording, you can return to the condition before
the recording started (UNDO operation). Therefore,
you can try recording again.
If you press the [UNDO/REDO] key again (after
UNDO), the undo operation is canceled and you
can return to the condition when the recording
finished (REDO operation).
38

Starting recording

While holding down the [RECORD] key, press the
[PLAY] key to start recording.
The guitar is recorded.
When recording completes, press the [STOP] key
to stop the recorder.
<Note>: We recommend to press the [ REC
SELECT ] key for track 1 to unarm track 1.

Playing back the recorded track

Press the [REWIND] key while holding down the
[STOP] key to locate the recorder to the
beginning of the song.
Press the [PLAY] key to start playback.
You can adjust the monitor level using the track
1 fader, as well as the [MASTER] fader and
[PHONES VOL] control.
If you are not satisfied with the result, use
the undo/redo function to cancel the re-
cording and try again.

Undoing recording (undo/redo)

15/16 > STEREO WAV FILE
HALL PLATE DELAY BOUNCE MODE
EFFECT BOUNCE
POWERFUL NATURAL BRIGHT TIMEBASE SELECT
MASTERING
EFFECT SEND
0 10
RHYTHM GUIDE
AUTO PUNCH PLAY MODE A / IN B / OUT
LOCATE
PAN
L R
VWX8 YZ9 +-_0 DELETE
REC SELECT REWIND
8 9/10 11/12 13/14 15/16 MASTER
MAX
LOCATE ABS ZERO
RECORD
MIN
The undo/redo function is available for
<Notes>:
all kind of recordings, however, if you carry out
any of the following operations after making re-
cording, you cannot undo the recording.
• Carrying out new recording.
• Carrying out track or part editing.
• Turning off the power.
• Selecting another song or editing the song name.
POWER
UNDO/REDO
MENU / ENTER
STORE UNDO/REDO
DIRECT LOCATE
CONTRAST
F FWD
[UNDO/REDO] key
LOCATE REC END
STOP PLAY
A-B PLAY