Loading From An Audio Cd - Fostex VF160EX Operation Manual

Loading from an audio CD

You can load a desired song to the unit from an audio CD you created by recording on a CD-RW/CD-R disc.
When a desired song is loaded, the unit automatically creates a new program on the current drive, and the song
are recorded on tracks 1 and 2 of the program. Loading data from an audio CD is operated via the "Load PGM"
menu in the Setup mode, which is the same way as loading backup data.
<Important note for copyright>
You can also load a material from a commercially
available audio CD in the same manner, however,
never use a material for which a copyright is re-
served for a commercial purpose.
Any unauthorized use will constitute infringement
of such copyright and will render the infringer li-
able to an action at low. Please remember that
data included in a commercial audio CD (CD-DA)
with copy protection being turned on cannot be
loaded into VF160EX.
The following description is assumed that you have an
audio CD created by the VF160EX (or a commercially
available audio CD).
<Note>
Key operations of the VF160EX should be done after com-
pleting access to a CD-RW/CD-R disc.
1. After turning on the power of the VF160EX, load a
recorded audio CD disc to the CD-R/RW drive.
2. Press the [SETUP] key to enter the Setup mode.
3. Use the [JOG] dial to select (highlight) the "Load PGM"
menu and press the [ENTER/YES] key.
The display changes to show the screen for selecting the
source device of loading, on which "IDE" flashes.
4. While "IED" is flashing, press the [ENTER/YES] key.
The display changes to show the screen for selecting the
load mode, on which "CD-DA" flashes.
5. While "CD-DA" is flashing, press the [ENTER/YES] key.
The display now shows the warning message for the
copyright. By rotating the [JOG] dial, you can scroll the
message.
<Warning message>
The warning message for copyright shown on the
screen is as follows.
<Note>
If you do not agree with the warning message con-
tents, press the [EXIT/NO] key to quit loading.
The display briefly shows " Set Disable " and " Can't
Loading ", then returns to the mode select screen.
If you agree with the warning message contents, go
to the next step to continue the operation.
<Hint>
Flashing
When loading data using the S/P DIF digital signal,
the same message also appears after selecting the
load device to "SP DIF" and pressing the [ENTER/YES]
key.
6. If you agree to the message contents, press the
[ENTER/YES] key.
The display changes to show the screen for selecting the
load type, on which "One" flashes.
You can select a desired load type from among "One",
Flashing
"Select" and "All". See the following table for details about
each load type.
129
Warning!
You are responsible for use of this digital
device. Be sure to abide by the copyright
conditions of the source material.
Press "Enter/Yes" key if you agree with the
above.