Fostex VF160EX Operation Manual page 126

Event Enable setting
This setting allows you to select whether enabling (ON)
or disabling (OFF) the events stored between the clip-
board in and clipboard out points when burning a
material to an audio CD. See page 128 for details.
Enables events between the clipboard in and out
points. When making an audio CD, a mastered ma-
ON
terial is divided into tracks separated by the events
(default).
Disables events between the clipboard in and out
points. When making an audio CD, a mastered ma-
OFF
terial is not divided into tracks (i.e. a material is
burned as a single track).
To change the setting, press the [ENTER/YES] key when
the "CD-R/RW Setup" screen is shown. The current set-
ting starts flashing, showing it can be edited.
While flashing, use the [JOG] dial to select "ON" or "OFF",
then press the [ENTER/YES] key to confirm.
6. After setting the copy protection and event enable, press
the [EXIT/NO] key.
The display returns to the screen for selecting the save
mode, in which "CD-DA" now flashes.
7. While "CD-DA" is flashing, press the [ENTER/YES] key.
After showing "Please Wait!", the display shows the screen
for selecting the program(s) to be record.
In the screen, a number such as "01" or "02" shows the
track number, while "NON" shows that no program is
assigned to the track.
Flashing
8. Press the [ENTER/YES] key again.
The highest program number available on the current
drive starts flashing and its program title and the
recording time are also shown. At the top of the
program table, the total time of the program is shown.
9. Use the [JOG] dial to select a desired program and press
the [ENTER/YES] key.
The selected program is set to the first track.
• To record a single song to a CD-RW/CD-R disc, select
a program and press the [ENTER/YES] key, and then
go to step 10.
• To record more than one song to a CD-RW/CD-R disc,
repeat the procedure for selecting a program
described above (i.e. use the [JOG] dial to select a
program and press the [ENTER/YES] key) until
selecting all desired programs, and then go to step
10.
<Note>
If the program time shows " 00: 00" when selecting a pro-
gram as the screen example below, the CLIPBOARD IN
Flashing
and CLIPBOARD OUT points are not correctly set.
In other words, in the following conditions, the
CLIPBOARD IN and CLIPBOARD OUT points are
not regarded as being correctly set.
CLIPBOARD IN point = CLIPBOARD OUT point
CLIPBOARD IN point > CLIPBOARD OUT point
If you press the [ENTER/YES] key after selecting such a
program, the warning message as below appears on
the display and you cannot select the program.
"Void In!", "Void Out!", or "Void Data!"
It is possible to select a program that is not mixed down
if it holds the correct "IN" and "OUT" points.
However, if you record such a program to a CD-RW/
CD-R disc with the audio CD format, only track 1 and
2 can be recorded.
So, make sure that you select programs properly when
making an audio CD.
126
Flashing
Flashing