Fostex VF160EX Operation Manual page 101

If you delete the program from the list, all the programs
set to the subsequent steps automatically slide up, as
shown below.
If you select a desired program, the program set to the
selected step is replaced and other steps are not affected
(in the following example, "P03" set to "C03" is replaced
with "P08").
To delete (or replace) another program, repeat the
procedure shown above.
5. Press the [EXIT/NO] key to exit the "Chain Play List"
screen.
The display returns to the "Select Menu" screen where
the current option of the "Chain Play" mode setting is
flashing.
<Note>
If you delete or replace a program in the chain play
list when "Chain Play" is set to any option but "Off",
the "Chain Play" setting automatically changes to
"Off" (which is the default). Therefore, to execute
chain play after editing the chain play list, you must
make the "Chain Play" mode setting appropriately
again.
Deleting all programs from the chain play list
You can delete all the program in the chain play list
simultaneously.
1. Follow procedure steps 1) and 2) on page 100 to show
the "Chain Play List" screen.
(i.e. enter the setup mode and select "Chain Play List".)
2. While step 1 (C01) is highlighted (selected), press the
[ENTER/YES] key.
The program number set to step 1 (P01) starts flashing.
If step 1 ("C01") is not highlighted, use the [JOG] dial to
select step 1 and press the [ENTER/YES] key.
3. Use the [JOG] dial to select "END" and press the [ENTER/
YES] key.
All the programs in the list are deleted at once and the
screen shows as below ("C01: END" is shown in the chain
play list, which means no program is entered to the list).
<Note>
If you select any step but "C01" in procedure step
2) above and follow procedure step 3), programs
set to the selected and subsequent steps are
deleted from the list. For example, if you set "END"
to step 3 (C03) in the chain play list where ten steps
are currently set, programs set to steps 3 through
10 are all deleted, while programs set to steps 1
and 2 remain.
4. Press the [EXIT/NO] key repeatedly until the setup mode
exits.
The "Chain Play" mode setting is automatically changed
to "Off".
101