Compressor Channel Setting; Off - Fostex VF160EX Operation Manual

In the "Setup of the compressor channel" menu, the channel in which the VF160EX internal compressor function
should be activated can be setup. The compressor can be made to function in channels 13-14 or 15-16.
Regardless to this setting, the compressor can be applied at all times to the master channel.
<Note>
The VF160EX internal compressor can be made to func-
tion only in the channel setup here and the master chan-
nel. However, editing of EQ in channels other than the
master channel, is not permissible.
• Initial setting:

"Off"

• Options: "Off", "13-14" or "15-16"
* You can set the mode for each program individually.
* The settings can be saved and loaded as part of the
song data.
* Although the setup content will not be held at switch
off of power, it can be saved as a scene memory.
1. Select "Comp. Channel" in the menu selection display and
press the [ENTER/YES] key.
The currently set will flash. "Off" will flash in the initial
setting.
2. Select the desired comp. Channel with the [JOG] dial
and press the [ENTER/YES] key.
The selected item will be set.
Compressor can be applied only in
Off
the master channel.
(Initial setting)
The compressor can be applied to
13-14
channels 13/14 and the master
channel.
The compressor can be applied to
15-16
channels 15/16 and the master
channel.
3. Press the [EXIT/NO] key (or [STOP] key) to exit from the
SETUP mode.
Compressor Channel Setting ["Comp. Channel"]
Flashing
<Important!>
EQ cannot be applied to the channel (Except the master
channel) setup for the compressor.
With the compressor channel setup, if the EQ editing
mode is entered, this condition will be indicated by the
[CH STATUS/CH SEL] key LED.
The channel in which the LED (green) is blinking is an
indication that EQ editing is possible in this channel and
the channel in which the LED is not lit is an indication
that EQ cannot be applied to this channel.
If a channel that cannot be EQ editing had been selected,
the "Can't Select!" message will blink to warn that the
operation is ineffective.
The schematic below is an example of channels 15-16
setup as the compressor channel.
Flashing
148
This is indicating that channels 15 and 16
are setup as the compressor channel.