Savant PAV-AOMBAL8C Quick Reference Manual

Savant® ProAV 16 Channel Balanced Audio Output IP Receiver
with Control (PAV-AOMBAL8C)
Quick Reference Guide
Box Contents
(1) 16 Channel Balanced Audio Output IP Receiver
(PAV-AOMBAL8C-xx)
(1) Installation Kit (075-0204-xx)
(8) Stereo Connectors (028-9347-xx)
(2) 3-pin Control Connector (028-9351-xx)
(1) 5V 3A Multi-Blade Power Supply (025-0223-xx)
(1) Product Information and Regulatory Insert (009-1950-xx)
Specifications
Environmental
Temperature 32° to 104° F (0° to 40° C)
10% to 80% Relative Humidity
Humidity
(non-condensing)
Dimensions and Weight
Height 1.6in (41.5 mm)
Width 8.5in (215.0 mm)
Depth 3.7in (93.3 mm)
Weight Net: 1.4lb (0.64 kg) Shipping: 2.3lb (1.05 kg)
Power
Power Supply 5V DC 3A Multi-Blade
Maximum Power 15 watts
Power over Ethernet
(PAV-AOMBAL8C-10 Only) IEEE 802.3af
(PoE)
Networking
Supported IEEE 802.1 AVB/TSN switches
Standard IEEE 802.3 Ethernet
Regulatory
FCC Part 15
Safety and Emissions
RoHS Compliant
Supported Releases
PAV-AOMBAL8C-00 da Vinci 8.10.2 and higher
PAV-AOMBAL8C-10 da Vinci 8.10.2, 9.3.4 and higher
Network Requirements
For networking guidelines and recommendations, refer to the Savant
Device Networking Guidelines available on the
Knowledge Base.
PAV-AOMBAL8C-xx Quick Reference Guide | 009-1605-02
Copyright 2021 Savant Systems, Inc | 210120
CE C-Tick
Savant Community
1 of 2
Front Panel
Power Status
A B
Green: System has power and is operating
A
Power LED normally.
Off: System is not receiving power
Off: Embedded processor is resetting, or is
powered up, and is booting the embedded
firmware.
Green: Host has established communications
with the embedded system.
Green Blinking: Embedded system is ready, but
no communication has been established with the
host.
Repeat
1s
Red: Host has determined the firmware needs to
be updated, but a problem occurred during the
process that will initiate a reset.
B
Status LED
Red Blinking: Embedded firmware is running, but
has not received a DHCP IP Address.
Repeat
1s
Amber: Host is updating the embedded
firmware.
Amber Blinking: Embedded system has a valid
link-local IP Address and is connecting to the
host.
Repeat
1s
Installation
The PAV-AOMBAL8C should be installed on a solid, flat, level surface.
The device will fit on a 1U rack shelf. The location should be dry, well
ventilated, and out of direct sunlight.
IMPORTANT! The PAV-AOMBAL8C must to be connected to a AVB
Switch. Also a Savant AVB audio input device is required.
.
1s
1s
1s
45 Perseverance Way, Hyannis, MA 02601
Savant.com | 508.683.2500