Savant ProAV 16 Quick Reference Manual

Savant® ProAV 16 Channel Audio Output IP Receiver with Control
Quick Reference Guide

Box Contents

(1) 16 Channel Audio Output IP Receiver (PAV-AOM8C-xx)
(1) Installation Kit (075-0195-xx)
(2) 3-pin Control Connector (028-9351-xx)
(1) 5V DC 3A Power Supply (025-0223-xx)
(1) Product and Regulatory Insert (009-1950-xx)

Specifications

Environmental

Temperature 32° to 104° C (0° to 40° C)
Humidity 10% to 80% Relative Humidity (non-condensing)

Dimensions and Weight

Height
1.6 in
Device
(4.15 cm)
2.2 in
Shipping
(5.59 cm)
Rack Space 1U

Power

Input 5V DC 3A
Maximum 15 Watts
Power over
IEEE 802.3af
Ethernet (PoE)

Networking

Supported IEEE 802.1 AVB/TSN switches
Standard IEEE 802.3 Ethernet

Regulatory

FCC Part 15
Safety and
Emissions
RoHS Compliant

Minimum Supported Releases

da Vinci 8.10.1, 8.10.2
Savant OS
da Vinci 9.1.1 and higher

Network Guidelines

For more information, see the Savant Device Networking Guidelines
on the Savant Customer Community.
PAV-AOM8C Quick Reference Guide | 009-1563-04
Copyright © 2021 Savant Systems, Inc. | 210621
Width Depth Weight
8.5 in 3.7 in 1.4 lbs
(21.50 cm) (9.33 cm) (0.64 kg)
12 in 7.3 in 2.3 lbs
(30.48 cm) (18.54 cm) (1.05 kg)
CE C-Tick

Front Panel

Power Status
A B
A
Power LED
B
Status LED

Installation

The PAV-AOM8C should be installed on a solid, flat, level surface. The
UKCA
device will fit on a 1U rack shelf. The location should be dry, well
ventilated, and out of direct sunlight.
IMPORTANT! The PAV-AOM8C must be connected to a AVB
Switch. Also a Savant AVB audio input device is required.
Rack
The optional RMB-PAVAM2F-xx or RMB-PAVAM2-xx allows two
devices to be mounted side by side. This rack is compatible with all
standard 19-inch National Electrical Manufacturers Association (NEMA)
rack mounts.
The instructions below show the RMB-PAVAM2F-xx, both brackets
install the same way they just face different directions.
1. Align the bracket with the device's mounting points.
2. Attach using the screws provided with the bracket.
1 of 2
Green: System has power and is operating
normally.
Off: System is not receiving power.
Off: Embedded processor is resetting, or is
powered up, and is booting the embedded
firmware.
Green: Host has established communications with
the embedded system.
Green Blinking: Embedded system is ready, but
no communication has been established with the
host.
Red: Host has determined the firmware needs to
be updated, but a problem occurred during the
process that will initiate a reset.
Red Blinking: Embedded firmware is running, but
has not received a DHCP IP Address.
Amber: Host is updating the embedded
firmware.
Amber Blinking: Embedded system has a valid
link-local IP Address and is connecting to the
host.
45 Perseverance Way, Hyannis, MA 02601
Savant.com | 508.683.2500