Setting-Up Projector; Connecting Ac Power Cord - Sanyo PLC-SL15 Owner's Manual

PREPARATION
This projector uses nominal input voltages of 100-120 V or 200-240
V AC. This projector automatically selects the correct input
voltage. It is designed to work with single-phase power systems
having a grounded neutral conductor. To reduce risk of electrical
shock, do not plug into any other type of power system.
Consult your authorized dealer or service station if you are not sure
of the type of power being supplied.
Connect the projector with all peripheral equipment before turning
the projector on. (Refer to pages 11 ~ 13 for connection.)
CAUTION
For safety, unplug AC Power Cord when the projector is not in
use.
When this projector is connected to an outlet with AC Power
Cord, it is in Stand-by mode and consumes a little electric
power.
NOTE ON THE POWER CORD
AC Power Cord must meet requirement of the country where you use a projector.
Confirm an AC plug type with the chart below and proper AC Power Cord must be used.
If supplied AC Power Cord does not match your AC outlet, contact your sales dealer.
Projector side
To POWER CORD
CONNECTOR on your
projector.
8

SETTING-UP PROJECTOR

CONNECTING AC POWER CORD

For the U.S.A. and Canada
Ground
To the AC Outlet.
(120 V AC)
Connect AC Power Cord (supplied) to the projector.
The AC outlet must be near this equipment and must
be easily accessible.
AC Outlet side
For Continental Europe
To the AC Outlet.
(200 - 240 V AC)
For the U.K.
To the AC Outlet.
(200 - 240 V AC)