Adjusting The Throttle Cable - Stihl BR 800 Instruction Manual

English
3.4.2 Removing the Nozzle
3
2
► Rotate the nozzle (1) in the direction of the
arrow until the lugs (3) are covered.
► Pull the nozzle (1) off the blower tube (2).
3.5 Adjusting the Blower Tube
1
2
► Loosen the union nut (1).
► Pull the blower tube (2) out to the required
length.
► Tighten the union nut (1).
3.6 Wear Mark on Nozzle
The front end of the nozzle wears away due to
abrasive ground contact during operation. The
nozzle is subject to normal wear and tear and
must be replaced when the wear mark is
reached.
3.7 Transport Aid
The blower tube can be hooked to the blower
housing for storage and transport.
8
1

4 Adjusting the Throttle Cable

► Attach D-ring to the hook on the blower hous‐
ing.
WARNING
Air or dirt particles can be blown into the user's
face and eyes if the engine is started while the
blower tube is still on the hook.
► Unhook the blower tube before starting the
engine.
NOTICE
If clothing or other objects are hung on the hook,
the intake openings may be covered and cause
the engine to overheat.
► Use the hook only for hanging up the blower
tube for storage or transport.
► Do not hang clothing or other items on the
hook.
4 Adjusting the Throttle
Cable
It may be necessary to correct the adjustment of
the throttle cable after assembling the machine
or after a prolonged period of operation.
Adjust the throttle cable only when the unit is
completely and properly assembled.
► Set the throttle trigger to the full throttle posi‐
tion.
0458-490-8321-B