Adjusting The Throttle Cable - Stihl SR 200 Instruction Manual

4 Adjusting the Throttle Cable

► Tighten down the screw (arrow).
3.2 Mounting the Control Handle
► Open up the control handle (1) with liner (2)
and push it over the stub (3) of the pleated
hose.
► Attach throttle cable to retainer (4).
► Secure hose with retainer (5) to third pleat
(arrow) in pleated hose.
3.3 Mounting the Blower Tube and
Nozzle
2
► Push the blower tube (1) into the stub of plea‐
ted hose (2) as far as the stop.
► Push the nozzle (3) onto blower tube as far as
stop – metering knob (4) must be in line with
the control handle.
3.4 Adjusting and Securing the
Control Handle
► Put the machine on your back and adjust the
harness – see "Harness".
0458-457-0121-C
2
1
3
5
4
4
3
1
1
► Slide the control handle (1) along the tube to
the most comfortable position – distance
between nozzle outlet (2) and the control han‐
dle (1) must be at least 500 mm (20 in) (a).
1
► Secure the hose clamp (1) with the screw (3).
4 Adjusting the Throttle
Cable
It may be necessary to correct the adjustment of
the throttle cable after assembling the machine
or after a prolonged period of operation.
Adjust the throttle cable only when the unit is
completely and properly assembled.
► Set throttle trigger to the full throttle position –
as far as stop.
► Carefully rotate the screw in the throttle trigger
in the direction of the arrow until you feel initial
resistance. Then rotate it another full turn.
English
a
2
3
9