Adjusting The Throttle Cable - Stihl BR 350 Instruction Manual

4 Adjusting the Throttle Cable

2
► Push the pleated hose (4) over the slip ring (2)
as far as stop.
► Position the hose clamp (3) as shown in the
illustration.
► Tighten down the screw (arrow).
Mounting the blower tubes and nozzle
5
► Assemble the blower tubes (5) and nozzle (6).
Mounting the control handle
3
0458-456-8321-E
3
4
6
5
7
► Pull the ends of the clamp on the control han‐
dle (7) apart and push it over stub of pleated
hose (4).
► Attach throttle cable to retainer on the hose
clamp (3).
Adjusting the Control Handle
► Put the machine on your back and adjust the
harness – see "Fitting the Harness".
► Push the blower tube (5) into the stub of plea‐
ted hose (4) as far as the stop.
► Move the control handle (7) along the tube to
the most comfortable position.
► Tighten down the screw on the control han‐
dle (7).
4 Adjusting the Throttle
Cable
It may be necessary to correct the adjustment of
the throttle cable after assembling the machine
or after a prolonged period of operation.
Adjust the throttle cable only when the unit is
completely and properly assembled.
► Set throttle trigger to the full throttle position –
as far as stop.
► Carefully rotate the screw in the throttle trigger
in the direction of the arrow until you feel initial
resistance. Then rotate it another full turn.
English
7
5
7