BenQ PD Series User Manual page 21

6. Connect the power cable to the monitor.
Plug one end of the power cord into the socket labelled
on the rear of the monitor. Do not connect the
other end to a power outlet just yet.
7. Install the back cover.
Gently lift the display up and extend it to the maximum
extended position. Then tilt the monitor to
install/remove the I/O cover easily.
Align the back cover with the holes on the back of the
monitor, and press both sides and the upper part of the
cover against the holes to lock it into place as
illustrated.
Push the lower part of the back cover toward the
monitor to secure it.
8. Organize the cables.
Route the cables via the cable clip.
9. Connect-to and turn-on the power.
Plug the other end of the power cord into a power
outlet and turn it on.
Picture may differ from product supplied for your region.
1
How to assemble your monitor hardware
2
21