Install The M.2 Drive Retainer - Lenovo ThinkSystem ST50 V2 Setup Manual

About this task
Step 1. Make sure the 2.5-drive is removed from drive bay 2, see "Remove a simple-swap drive (bay 1-2)"
on page 55.
Step 2. Make sure the post on the M.2 drive retainer is lifted away from the retainer.
Step 3. Install the M.2 drive.
Note: The thermal sensor cable should be placed under the M.2 drive.
a. Position the M.2 drive at an angle and insert it to the M.2 connector.
b. Place down the M.2 drive onto the M.2 drive retainer.
c. Insert the retainer post into the retainer to secure the M.2 drive in place.
Figure 68. Installing the M.2 drive

Install the M.2 drive retainer

Follow this procedure to install the M.2 drive retainer.
S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off the
electrical current supplied to the device. The device also might have more than one power cord. To
remove all electrical current from the device, ensure that all power cords are disconnected from the
power source.
.
Chapter 3 Server hardware setup
85