Lenovo ThinkSystem ST50 V2 Setup Manual page 85
Machine types: 7d8j and 7d8k
Hide thumbs
Also See for ThinkSystem ST50 V2:
- Maintenance manual (192 pages) ,
- Quick start (2 pages) ,
- Maintenance manual (192 pages)
Table of Contents
Advertisement
Step 1.
Before installing the front fan, remove the front bezel, see "Remove the front bezel" on page 51.
Step 2.
Install the front fan or rear fan.
a.
Align the four rubber mounts on the fan with the corresponding holes on the chassis.
b.
With a pair of pliers, gently pull the tips of the four rubber mounts though the holes until the
fan is secured to the chassis.
Figure 64. Installing the front fan or the rear fan
Note: Make sure the rubber mounts are fully pulled out of the holes to secure the fans steadily
to the chassis.
Figure 65. Front fan and rear fan rubber mounts installation
Step 3.
Connect the fan cable to the system board, see "Internal cable routing" on page 19.
.
Chapter 3
Server hardware setup
81
Advertisement
Table of Contents
