Install The Intrusion Switch - Lenovo ThinkSystem ST50 V2 Setup Manual

Attention:
• Read "Safety inspection checklist" on page 43 and "Installation Guidelines" on page 41 to ensure that you
work safely.
Watch the procedure
A video of this procedure is available at YouTube:
AU3iY3F7lq3qfqr5caGbIu
Procedure
Step 1. Make sure the cage bar is installed in the chassis. To install the cage bar, see "Install the server
cover" on page 92.
Step 2. If necessary, install the 3.5-inch drive assembly to the optical drive cage. See "Install a simple-
swap drive and the drive cage (bay 3)" on page 65.
Step 3. Install the optical drive cage.
a. Align the four pins on the sides of the optical drive cage with the four slots on the chassis
and cage bar; then, lower the optical drive cage into the chassis.
b. Ensure the optical drive cage is seated correctly; then, rotate the optical drive cage handle
toward the front of the chassis to secure the optical drive cage into place.
Figure 61. Installing the optical drive cage
Step 4. If applicable, connect the signal and power cable of the 3.5-inch drive to the system board, see
"Internal cable routing" on page 19.

Install the intrusion switch

Follow this procedure to install the intrusion switch.
ThinkSystem ST50 V2 Setup Guide
78
.
https://www.youtube.com/playlist?list=PLYV5R7hVcs-