Table of Contents
Advertisement
MOLDBOARD & A-FRAME ASSEMBLY – 810TR, 8100TR & 8611TR MODELS
1. Remove dust cap from both of the slide box
cylinders located at the center/rear of the
moldboard. Attach adapters (B60007 for 810TR;
56695 for 8611TR) to both ports on each slide box
cylinder. Tighten fi ttings per torque chart.
NOTE: All of the hydraulic adapters can be found
packaged with the manifold assembly.
Extend
Retract
NOTE: The positions for the rod- and base-end
slide box hoses. The hoses that operate the
retract functions (rod) of the cylinders are
closest to the base of each cylinder. The hoses
that operate the extend functions (base) of the
cylinders are closest to the rod of each cylinder.
2. Connect hoses (B60223 for 810TR; 49501 for
8611TR) to each of the hydraulic adapters on the
cylinders. Tighten hoses per torque chart.
NOTE: Review the label on each hose for the
appropriate part number.
9/16
9/16
40571
• Angle Cylinders
Lit. No. B64092, Rev. 09
B60340
• Manifold Port T
9/16
9/16
B60007
• Slide Box Cylinders (810 only)
• Manifold Ports P2 & P3
• Manifold Ports #1,2,7,8,9 & 10 (8611 only)
3. Position the front (top) hole in the A-frame with the
middle hole in the pivot beam. Insert cap screw
(50605) through the top, and secure on the bottom
with washer (B61203) and nut (B61008).
4. Position the pivot beam and A-frame near the
mount locations at the rear of the blade. Place
the right and left group of hydraulic hoses
(connected to the slide box cylinders) through the
1-1/2" diameter rubber grommet openings in the
front face of the pivot beam.
3/4
3/4
9/16
B60272
• Slide Box Cylinders (8611 only)
• Manifold Ports #1,2,7,8,9 & 10 (810 only)
13
9/16
April 15, 2021
Advertisement
Table of Contents
