Table of Contents
Advertisement
Tag axle
Toe: ............................ 0" ± 1/16" (0 mm ± 1,6 mm)
HEATING AND AIR
CONDITIONING
Driver's system
Refrigerant type:.......................................... R-134a
Heating capacity:.............................. 37,800 Btu/hr.
Air flow:............................450 cfm (12,74 m
Central system
Air conditioning capacity: ..110 000 Btu/hr. (XL-45)
Air conditioning capacity: ....98 000 Btu/hr. (XL-40)
Refrigerant type:.......................................... R-134a
Heating capacity:............................ 152,000 Btu/hr.
Air flow:.........................2,700 cfm (76,45 m
A/C COMPRESSOR
Number of cylinders:............................................. 6
Operating speed: ........................ 400 to 2,200 rpm
Minimum speed for lubrication:..................400 rpm
Oil capacity:......................1.13 U.S. gal. (4,3 liters)
Approved oils: ......................Castrol SW-68 (POE)
NOTE: The above oils are suitable for use with
reciprocating compressors using refrigerant R-
134a and with evaporator temperatures above
-40 ° F (-40 ° C).
OIL SPECIFICATIONS
Engine
Heavy-duty engine oil SAE 15W-40 meeting
MIL-L-2104E or F specification.
Transmissions
Automatic
The transmission must be filled with DEXRON IIE
or III automatic transmission fluid or any
equivalent Class C4 fluids.
3
/min.)
3
/min.)
(1,750 rpm, nominal)
Mobil Artic 1 (POE)
Manual
Same as engine oil.
Differential
Multigrade gear lubricants are recommended for
use in drive axle. These lubricants perform well
over broad temperature ranges, providing good
gear and bearing protection in a variety of
climates.
Two categories of multigrade gear lubricants may
be used according to the climate in which you
drive.
Climate
Northern..................................................... 75W-90
Southern .................................................. 80W-140
Fan gearbox
Synthetic oil Mobil SHC 634 is recommended for
the fan gearbox.
Power steering reservoir
This reservoir must be filled with DEXRON IIE or
III automatic transmission oil.
Wheel bearings
The front and tag axle wheel bearings must be
filled to the level mark in the cap using SAE 90 oil.
Drive axle wheel bearings are lubricated by the
differential oil.
ensure adequate lubrication of drive axle wheel
bearings at all times.
On vehicles equipped with grease-lubricated
wheel bearings, pack with wheel bearing grease.
A/C compressor
Polyolester oil, HFC 134A compatible; Castrol
SW-68 (POE) or equivalent.
Clutch master cylinder
This reservoir must be filled with DOT 3 heavy-
duty brake fluid.
5 - 5
TECHNICAL INFORMATION
Maintain differential oil level to
Lubricant
Advertisement
Table of Contents
