Table of Contents
Advertisement
1) BEFORE OPERATING VEHICLE, PERFORM EACH POINT LISTED IN "STARTING AND STOPPING
PROCEDURES" SECTION UNDER HEADING "DAILY INSPECTION... " (PAGE 4-9).
NOTE: Perform the "FIRST SERVICE ON NEW VEHICLE" as outlined on page 6-13.
DAILY WALK-AROUND INSPECTION
It is a good practice to make a basic visual inspection of key areas on the vehicle on a daily basis and to
report any problem areas to maintenance personnel for immediate correction.
A) Outside the vehicle
ITEM*
---
Check for leaks under vehicle and engine compartment
---
Check that baggage and service compartment doors close properly
---
Inspect tires and wheels for correct tire pressure, wear or damage, and for missing wheel stud and nuts
1
Check windshield washer fluid level and add if necessary
---
Check condition of windshield wiper blades
---
Verify proper operation of all road lights, signal lights, brake lights, marker lights, and back-up lights;
Replace light bulbs as required
3 & 24
Drain accumulated water in accessory and wet air tanks
B) Engine compartment
ITEM*
22
Check engine crankcase oil level; Add if necessary
18
Check automatic transmission oil level (level can be checked from pushbutton shift selector);
Add if necessary
25 & 39
Check air cleaner restriction indicator, replace air cleaner when red flag locks in full view
27
Check power steering reservoir fluid level; Add if necessary
20
Check coolant surge tank fluid level; Add if necessary
26
Drain accumulated water in primary fuel filter/water separator (if equipped)
* Item numbers refer to figure on page 6-14.
DESCRIPTION
DESCRIPTION
6 - 15
CARE & MAINTENANCE
Advertisement
Table of Contents
