Table of Contents
Advertisement
a
H
larm
iStory
This menu allows the user to view all triggered alarms (past or present).
1. Enter the Programming menu by pressing
2. Use
to scroll the Programming menu and select E) ALARM HISTORY.
3. Press
.
The display will show the last 100 alarms that were triggered.
4. Use
to scroll through the last 100 alarms.
For each triggered alarm, the display shows the conditions at the time of that particular alarm, as shown on the example
below:
Time
INDEX and alarm name
Setpoint
Setpoint Band
**
**
**
**
Power Off: Indicates a power failure. The alarm is recorded when power is back on.
Factory Reset: Factory reset procedure was performed.
NOTE: Power Off and Factory Reset are not alarms, but the controller saves these events in this logging.
For alarm names and descriptions, refer to the Alarm System on page 32.
R
. The display will read:
PROGRAMMING MENU
G>VERSION INFO
A>UNIT ON/OFF
B>USER SETUP
16 : 47 : 48
003:Obstr water filter
SP:
028.0
Band:
07.0
Pump.
Pump valve.
Air vent val.
Drain valve.
Water treat.
*
Only shown when system uses modulating pump
**
If shown, device was ON when alarm was triggered
2021/05/05
Pump: 079%
OT: 010.0
FT: 031.3
Date
**
*
Pump Speed
Outside Temperature
Fluid Temperature
31
Advertisement
Table of Contents
