Table of Contents
Advertisement
STATUS MENU (SYSTEM STATUS & RUN HOURS)
When the controller is powered ON, it shows screen 1 of the Status menu. The Status menu has 3 screens. Each one shows
important information regarding the status of the controller and the adiabatic system, such as time and date, controller status
(ON/OFF), operating time, etc. No data can be entered or modified in the Status menu. The Status menu will show
default screens until the controller has been setup in the Programming menu.
Controller Status ON/OFF
Cooling Demand
Status of water pump
3
Status of pulsing valve
4
Status of air vent
Status of drain valve
Status of UV light
Press
to access Status screen 2.
Status screen 2 shows the operating time of the four main devices since the last maintenance:
• Water pump: pump operating time since last oil change (only for MP).
• Water filter: filter operating time since last change.
• UV lights: ultraviolet lights operating time since last change.
• Demineralizer: demineralizer operating time since last maintenance.
Press
to access Status screen 3.
Status screen 3 shows the total operating time of the four main devices.
R
STATUS SCREEN 1
Time
16 : 47 : 48
Status:OFF
CD:000%
1
Pump status:
(only for PV)
Pulsing valve:
(only for PV)
Air vent valve:
Drain valve:
Water treatment:
Indicates the cooling demand depending on the fluid temperature (or on outdoor temperature if set).
1
An arrow pointing this line indicates the system is being controlled by this temperature.
2
Indicates pump speed when operating with modulating pump.
3
Indicates pump outlet valve status when operating with modulating pump.
4
TIME SINCE LAST
MAINTENANCE
Water filter:
UV lights:
Demineralizer:
DEVICES RUN HOURS
Water pump:
Water filter:
UV lights:
Demineralizer:
Date
2020/05/05
OT: 010.0
C
o
FT: 024.7
C
o
OFF
CLOSED
OPEN
OPEN
OFF
00000hrs
00000hrs
00000hrs
000hs
000hs
000hs
000hs
Outdoor Temperature
2
Fluid Temperature
2
13
Advertisement
Table of Contents
