Step 1: Attach Outside Antenna To The Vehicle's Roof; Step 2. Install The Inside Patch Antenna - SureCall Fusion2Go Max User Manual

Step 1: Attach Outside Antenna to the Vehicle's Roof

Attach the Outside Antenna to the roof of your vehicle and at least 12-inches away from
obstructions and other radiating elements, like other antennas.
Suggestion: For non-metal or non-magnetic
vehicle surfaces use the optional adhesive tape.
Next, run the cable from the outside antenna across
the car's roof and into the car. To hide and protect
the antenna cable, carefully pull down the door
seal, run cable underneath it and push the seal
back into place. Run the cable to the inside of the
vehicle near the planned location of the booster
(under the seat of the vehicle, or in the front or
middle console).
Note: The outside antenna must not be collocated or operating with any other antenna or booster.

Step 2. Install the Inside Patch Antenna

Identify a location for the inside antenna on or near your front dashboard that is
1. Within 2-3 feet of the typical cell phone location
2. At least 8 inches (20cm) from cellular devices
and
3. At least 4 inches (10cm) from metal
Next, peel Velcro backing and apply to a clean dry
surface in your chosen location.
Or try this - Use the free vent clip provided with
your product as a mounting surface then simply
clip to an air vent.
SureCall Fusion2Go Max User Guide
https://www.signalbooster.com | 1-855-846-2654 | order@signalbooster.com
5