Toro POWER CLEAR 721 Service Manual page 57

Shroud Installation (continued)
POWER CLEAR® 721/821 Snowthrower Service Manual
3438-776 Rev A
g320931
3. Install the 2 (1/4-20 x 1 inch) screws securing the front of the shroud to the
auger housing.
4. Install the 2 (1/4-10 x 13/16 inch) screws securing the LH shroud retainer to
the LH shroud. Remove the LH shroud retainer. Repeat the procedure on
the RH side of the machine
g320930
5. Install the chute seal ring to the shroud, secure with a screw (M4.2–2.25
mm x 3/4 inch).
Figure 48
Figure 49
Page 5–11 Chassis: Service and Repairs