Toro POWER CLEAR 721 Service Manual page 34

Electric Starter Removal (continued)
Electric Starter Installation
Engine: Service and Repairs
2. Remove the 2 (#6 x 2.5 in) screws securing the electric starter switch box to
the shroud.
3. Unwind the harness retainer clip and remove the electric starter wire from the
harness retainer clip.
g323979
4. Remove the 2 (M6 x 35 mm) bolts securing the electric starter to the engine.
Note: If the dowel pins were inadvertently removed, retain for installation.
g323978
5. Remove the electric starter from the engine.
1. If the dowels were inadvertently removed, install the dowel pins.
Figure 15
Figure 16
Page 4–10 POWER CLEAR® 721/821 Snowthrower Service Manual
3438-776 Rev A