Operation - Silvercrest SSSES 1.5 B2 Operating Instructions Manual

NOTE
► During filling pay attention to the marking max
the soap tank
marking max
flow.
6. Place the soap tank latch
and turn the soap tank latch
place. Shake the soap tank
and liquid soap.
7. Place the main appliance
Then turn the soap tank
and secure on the main appliance
now ready for use.

Operation

1. Flip up the control panel cover
Press and hold the On/Off button
seconds. The green LED
2. Briefly press the soap quantity button
lights up once briefly.
For a larger soap quantity press the soap quantity button
briefly one more time. The green LED
3. Hold your hand underneath the soap dispenser
sensor
soap.
4. As soon as the soap dispenser
your hand.
NOTE
► The soap dispenser
your hand. This is true even if the programmed quantity has
not yet been dispensed.
5. If you do not intend on using the appliance for an extended
period of time, press the On/Off button
3 seconds to switch off the appliance. The red LED
up for approx. 3 seconds.
NOTE
► If the appliance has not been used for a few days it may be
necessary to operate the soap dispenser
succession before the appliance will dispense any soap.
■ 8 │ GB │ IE
8
. Never fill the soap tank
0
. Otherwise the soap tank
6
activates and the appliance begins to dispense
5
9
back onto the soap tank
9
clockwise until it locks into
8
a few times to mix the water
7
back onto the soap tank
8
clockwise until it is sitting tight
7
. The appliance is
1
on top of the appliance.
3 for approx. 3
u
lights up for approx. 3 seconds.
u
5
stops, you can remove
also stops as soon as you remove
0
on
8
above the
8
will over-
8
8
z
. The green LED
lights up briefly twice.
5
. The
3
for approx.
2
lights
5
a few times in
SSSES 1.5 B2
.
u
z