Fill Soap Tank; Mix Soap; Filling In Soap; Operation - Silvercrest SSSES 1.5 A1 Operating Instructions Manual

7. Fill soap tank

7.1 Mix soap

If you would like to use normal cream soap, then mix it first with
water. Without adding water, normal cream soap is so too vis-
cous to be processed.
• On the mixing bottle 12 there are two markings:
- 1:2: add 1 part of cream soap and 2 parts of water into
the mixing bottle.
- 1:3: add 1 part of cream soap and 3 parts of Water into
the mixing bottle.
1. Screw the lid 11 off the mixing bottle 12.
2. Add cream soap up to the marking into the mixing bottle.
3. Add water to the mixing bottle. The contents should reach
the marking MAX.
4. Close the mixing bottle 12.
5. Shake the contents thoroughly. Then, the soap solution can
be put into the soap tank 6.

7.2 Filling in soap

1. Flip the lid 1 open.
2. Pour the soap mixture into the soap tank 6
(at least to the marking min 7, no more than to the marking
max 5).
3. Close the lid 1.

8. Operation

NOTE: the soap tank must be filled.
1. Press the on/off switch 9 on the back.
The LED 8 lights up briefly once in yellow when it is switched
on.
2. Hold a hand under the outflow opening 3 and the sensor 4.
You will hear a noise and the LED 8 lights up yellow.
The soap is dispensed.
22
GB