Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for HIKVISION DS-K5603
Summary of Contents for HIKVISION DS-K5603
- Page 1 (Simplified) Simplified Edition-Face Recognition Swing Barrier Installation Guide_V1.1-20190215.docx Hikvision Product Support Team Face Recognition Swing Barrier Installation Guide (Simplified Edition) Date Content Person 20180908 Create Nero 20190215 Translate and Modify Morgen...
- Page 2 (Simplified) Simplified Edition-Face Recognition Swing Barrier Installation Guide_V1.1-20190215.docx Hikvision Product Support Team Content Face Recognition Swing Barrier ..............................1 1. Wiring ....................................3 2. Swing barrier study mode ............................5 3. Software configuration .............................. 6 4. Testing .................................... 8...
- Page 3 (Simplified) Simplified Edition-Face Recognition Swing Barrier Installation Guide_V1.1-20190215.docx Hikvision Product Support Team 1. Wiring 1） Power cable wiring: connect cable to air switch(L, N and GND)； NOTE：Power OFF before wiring to ensure safety. 2） Connect interconnecting cable between left and right barriers.
- Page 4 (Simplified) Simplified Edition-Face Recognition Swing Barrier Installation Guide_V1.1-20190215.docx Hikvision Product Support Team 3） Connect DS-K5603-Z to swing barrier. a. Connect power cable. There is a connecter inside barrier to provide power for face module(DS-K5603-Z) From face device From barrier 12V power supply b.
- Page 5 (Simplified) Simplified Edition-Face Recognition Swing Barrier Installation Guide_V1.1-20190215.docx Hikvision Product Support Team c. Connect swing barrier and face module to network switch. From barrier From face module Connect to PC There is no need to care about the sequence, it’s a normal switch, so that we can manage face module and swing barrier in software at same time, to ensure same data in two devices.
- Page 6 (Simplified) Simplified Edition-Face Recognition Swing Barrier Installation Guide_V1.1-20190215.docx Hikvision Product Support Team 3) After study mode finish(swing stopped moving), power off the device, adjust DIP switch as 00000000, power on device again. Device will open and close one time automatically.
- Page 7 (Simplified) Simplified Edition-Face Recognition Swing Barrier Installation Guide_V1.1-20190215.docx Hikvision Product Support Team 1) .Add device（activate in advance） Swing barrier control board K3M200 Face Recognition module：K5603-Z 2) Select K3M200 and enter Remote Configuration, enter page as below and select RS-485 Select 4 from drop-down list and set as front left picture, then select 6 from drop-down list and set other parameters same as front right picture.
- Page 8 Hikvision Product Support Team 4) Synchronize person data to swing barrier and face recognition module 4. Testing Verify card on card reader，barrier will open, after pass the barrier will close. Verify face on DS-K5603(T)-Z，barrier will open, after pass the barrier will close.
Need help?
Do you have a question about the DS-K5603 and is the answer not in the manual?
Questions and answers