Clutch Lever - Yamaha R15M Owner's Manual

Instrument and control functions
Push and briefly hold this switch down
to the start position "
engine with the starter.
TIP
 See page 7-2 for further instruc-
tions before starting the engine for
the first time.
 For certain models, the engine
warning light will come on when
5
the start switch is pushed, but this
does not indicate a malfunction.
Hazard lights switch " /OFF"
The hazard lights (simultaneous flash-
ing of all turn signal lights) are used in
case of an emergency, such as to warn
other drivers when your vehicle is
stopped where it might be a traffic haz-
ard.
Set this switch to " " to turn on the
hazard lights. To turn off the hazard
lights, set the switch to "OFF".
NOTICE
" to crank the
Do not use the hazard lights for an
extended length of time with the en-
gine not running, otherwise the bat-
tery may discharge.
"TRIP/INFO" switch
This switch is used to make setting and
display changes in the multi-function
meter unit.
To use the "TRIP" switch, move the
EAUN2211 "TRIP/INFO" switch in direction (a). To
use the "INFO" switch, move the
"TRIP/INFO" switch in direction (b).
ZAUE4465
1. "TRIP/INFO" switch
ECA10062
EAU78491
1
(a) (b)
5-17

Clutch lever

1
1. Clutch lever
The clutch lever is located on the left
side of the handlebar. To disengage
the clutch, pull the lever toward the
handlebar grip. To engage the clutch,
release the lever. The lever should be
pulled rapidly and released slowly for
smooth clutch operation.
The clutch lever is equipped with a
clutch switch, which is part of the start-
ing circuit cut-off system. (See page
5-25.)
EAU31642