Mode Configuration Dip Switches - Talk-a-Phone ETP-120 Series Installation & Operation Manual

5. Mode Configuration DIP Switches

Mode Configuration DIP Switches #1, 2, and 3 are provided to configure a number of modes as
outlined below.
Mode
Configuration
DIP Switch #
1
2
3
Page 9 of 27
Copyright 2021 Talk-A-Phone, LLC • 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • info@talkaphone.com • www.talkaphone.com.
All prices and specifications are subject to change without notice. Talk-A-Phone, Talkaphone, bAlert, Scream Alert, WEBS, and WEBS Contact are registered trademarks of Talk-A-Phone,
LLC. All rights reserved. All other trademarks mentioned in this document or website are the property of their respective owners and does not imply or indicate any approval, endorsement,
sponsorship, or affiliation with such owners unless such approval, endorsement, sponsorship, or affiliation is expressly indicated.
Position Function Description
ON Pushbutton is used to both place and disconnect calls
Pushbutton is only used to place calls
OFF
[Default]
Auto-answers inbound calls
ON
[Default]
OFF Does NOT auto-answer inbound calls
Normal operation mode
ON
[Default]
Learn mode - Any inbound calls automatically enter into
programming mode (no security code required).
Use this option if the security code has been lost or forgotten. Any
outbound call will dial Talkaphone Technical Support (see Section
6.11, Assisted Programming, p.18).
OFF
IMPORTANT NOTE: When finished programming, set this switch
back to the ON position or else the unit will only call Talkaphone
Technical Support instead of the programmed phone number(s).
ETP-120 Series Phone
Installation & Operation Manual
Rev. 7/2/2021