Table of Contents
Advertisement
Voice Message Codes
Voice messages allow for a pre-recorded message to play automatically when the answering point
(receiving end) answers the call. Typically, physical location information is provided through this voice
message to identify the unit to the answering point. The maximum length of a voice message is 16
seconds.
NOTE:
The voice message feature is NOT supported on calls placed via the Auxiliary Input.
The voice message code is comprised of six (6) digits in the following format—parameters A through F
are defined in the table below:
The factory default timing/dialing code is:
Parameter
Function Description
Two-Digit Voice Message
Delay. Sets the amount of time
required to elapse (1-99
seconds) after dialing the phone
number before the voice
message plays.
Factory set to automatically start
playing the voice message after
the ETP-120 unit has
A + B
determined the call has been
answered.
Important Note: If this delay is
used, adequate time must be
allowed for the unit to detect
ring-no-answer and busy signals
when used in conjunction with
redial features.
Repeat Voice Message. The
ETP-120 unit can be
programmed to play the voice
message from 1-9 times, or to
continuously repeat the voice
C
message every 8 seconds until a
touch tone * is detected from the
answering point. The
"ANSWERED" LED will turn on
automatically after the voice
message has stopped repeating.
Hang Up on Return to Dial
Tone. If enabled and a return
D
dial tone is detected, the ETP-
120 unit will hang up.
Double Ring Cadence Mode.
The ETP-120 unit can be
programmed to recognize the
double ring cadence that is
outputted by many phone
E
systems. If the ETP-120 unit is
connected to an extension that
provides a double ring cadence,
then enabling this mode will
allow for proper call progress
detection.
Page 16 of 27
Copyright 2021 Talk-A-Phone, LLC • 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • info@talkaphone.com • www.talkaphone.com.
All prices and specifications are subject to change without notice. Talk-A-Phone, Talkaphone, bAlert, Scream Alert, WEBS, and WEBS Contact are registered trademarks of Talk-A-Phone,
LLC. All rights reserved. All other trademarks mentioned in this document or website are the property of their respective owners and does not imply or indicate any approval, endorsement,
sponsorship, or affiliation with such owners unless such approval, endorsement, sponsorship, or affiliation is expressly indicated.
Installation & Operation Manual
A B C D E F # 1 7
0 0 1 2 1 0 # 1 7
Values
00
01
02
...
98
99
0
1
2
...
8
9
1
2
1
2
ETP-120 Series Phone
Definition
Play automatically
[Default]
1 second
2 seconds
...
98 seconds
99 seconds
Repeat every 8 seconds
Play 1 time
[Default]
Play 2 times
...
Play 8 times
Play 9 times
Disabled
Enabled
[Default]
Disabled
[Default]
Enabled
Rev. 7/2/2021
Advertisement
Table of Contents
