Security Code - Talk-a-Phone ETP-120 Series Installation & Operation Manual

Security Code

When Mode Configuration DIP Switch #3 is in the ON position, the ETP-120 Series Call Station will
require a security code before it can be programmed.
The default security code is: 827827 (or TAPTAP)
Talkaphone highly recommends that this security code be changed from the default value. To change
the security code, follow these steps:
1. Access programming mode as outlined in Section 3.2.
2. Enter:
NOTE:
The security code must be comprised of six (6) numeric digits.
3. Hang up or enter this code to disconnect:
If the security code is lost or forgotten, either reprogram the security code when Mode Configuration
DIP Switch #3 is set to the OFF position or reset the unit to factory defaults.
Page 12 of 27
Copyright 2021 Talk-A-Phone, LLC • 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • info@talkaphone.com • www.talkaphone.com.
All prices and specifications are subject to change without notice. Talk-A-Phone, Talkaphone, bAlert, Scream Alert, WEBS, and WEBS Contact are registered trademarks of Talk-A-Phone,
LLC. All rights reserved. All other trademarks mentioned in this document or website are the property of their respective owners and does not imply or indicate any approval, endorsement,
sponsorship, or affiliation with such owners unless such approval, endorsement, sponsorship, or affiliation is expressly indicated.
☐☐☐☐☐☐
# 19
ETP-120 Series Phone
Installation & Operation Manual
# 7
Rev. 7/2/2021