Assisted Programming; Operation Codes - Talk-a-Phone ETP-120 Series Installation & Operation Manual

Assisted Programming

If the phone number of the line connected to the ETP-120 Series Call Station is unknown, the call
station can be configured to automatically call Talkaphone Technical Support for assistance.
Set Mode Configuration DIP Switch #3 to the OFF position (programming mode) and activate the
pushbutton. The unit will then call Talkaphone Technical Support no matter if it is connected directly to
a PSTN line or on an analog PBX extension.
The unit will first dial 9 and listen for a second dial tone. If a second dial tone is detected, the unit will
then continue to dial the following:
1-773-539-1100, 12-second pause, 2, 16-second pause, 1
This call is long distance, so the phone line must support long distance calls.
NOTE:
If Mode Configuration DIP Switch #3 is not returned to the ON position, activating the pushbutton
will call Talkaphone Technical Support instead of the programmed phone number(s).

Operation Codes

The following codes can be used to perform functions during an active phone call:
Operation Code
*
#
Page 18 of 27
Copyright 2021 Talk-A-Phone, LLC • 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • info@talkaphone.com • www.talkaphone.com.
All prices and specifications are subject to change without notice. Talk-A-Phone, Talkaphone, bAlert, Scream Alert, WEBS, and WEBS Contact are registered trademarks of Talk-A-Phone,
LLC. All rights reserved. All other trademarks mentioned in this document or website are the property of their respective owners and does not imply or indicate any approval, endorsement,
sponsorship, or affiliation with such owners unless such approval, endorsement, sponsorship, or affiliation is expressly indicated.
Function Description
Three (3) functions:
(1) Play the voice message only (if recorded)
(2) Transmit the ID number (if programmed) only when no voice
message is recorded
(3) Transmit the ID number (if programmed), then play the voice
message (if recorded)
Immediately disconnect the call and hang up the ETP-120 unit (only
for outbound calls)
ETP-120 Series Phone
Installation & Operation Manual
Rev. 7/2/2021