Summary List Of Programming Codes - Talk-a-Phone ETP-120 Series Installation & Operation Manual

Summary List of Programming Codes

Programming Then
Code Enter
0-20 digits +
0-20 digits +
0-20 digits +
0-20 digits +
0-20 digits +
0-20 digits +
0-20 digits +
0-20 digits
0-20 digits
0-20 digits
6 digits +
6 digits +
6 digits +
0-20 digits +
0-20 digits +
6 digits +
* *
* #
* 7
[Enter No Digits] +
* 0
* 1
* 2
* 6
#
# 7
# # #
NOTE:
After each programming code, a double-beep indicates the code has been accepted. Four (4) beeps
indicate an error—re-enter the code again.
Page 13 of 27
Copyright 2021 Talk-A-Phone, LLC • 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • info@talkaphone.com • www.talkaphone.com.
All prices and specifications are subject to change without notice. Talk-A-Phone, Talkaphone, bAlert, Scream Alert, WEBS, and WEBS Contact are registered trademarks of Talk-A-Phone,
LLC. All rights reserved. All other trademarks mentioned in this document or website are the property of their respective owners and does not imply or indicate any approval, endorsement,
sponsorship, or affiliation with such owners unless such approval, endorsement, sponsorship, or affiliation is expressly indicated.
Memory Slot Function Description
#00 Primary autodial phone number for pushbutton
#01 Secondary autodial phone number for pushbutton
#02 Third autodial phone number for pushbutton
#03 Fourth autodial phone number for pushbutton
#04 Fifth autodial phone number for pushbutton
#05 Autodial phone number for central station receiver line
#06 Autodial phone number for central station voice line
#07 Primary autodial phone number for Auxiliary Input
#08 Secondary autodial phone number for Auxiliary Input
#09 Third autodial phone number for Auxiliary Input
#17 Voice message/other options. For further details, see Section 6.9, Voice
Message Codes, p.16.
[Default 001210]
#18 Timing/dialing options. For further details, see Section 6.8,
Timing/Dialing Codes, p.15.
[Default 234721]
#19 Change the security code
[Default 827827 or TAPTAP]
#20 Primary ID number for central station
[Default no ID number set]
#21 Secondary ID number for central station
[Default no ID number set]
#23 Talk-A-Lert ID number
Add a * at any point of the dial string
Add a # at any point of the dial string
Add 4-second pause at any point of the dial string
#00 through #06 Clear autodial phone numbers
Diagnostic tones to check microphone/speaker operation
Enable the Talk-A-Lert ID number to be transmitted when the ETP-120 unit
auto-answers an inbound call
Enable the Talk-A-Lert ID number to be transmitted when the remote side
answers the call (i.e. an outbound call)
Disable * 1 and * 2
[Default]
Disconnect or terminate an active outbound call only (i.e. cannot
terminate/disconnect inbound calls or programming mode calls)
Exit programming mode and disconnect
Reset to factory defaults
ETP-120 Series Phone
Installation & Operation Manual
Rev. 7/2/2021