Table of Contents
Advertisement
6. Software Programming
Quick Programming Guide
Programming the ETP-120 Series Call Station is relatively quick and easy. While it is recommended
that you read the complete manual before you begin, the following quick guide will serve many
applications.
NOTE:
After each ETP-120 Series programming code, a double-beep indicates the code has been accepted.
Four (4) beeps indicate an error—re-enter the code again.
1.
Call into the ETP-120 Series Call Station—it will answer with an open channel (microphone and
speaker are active).
2.
Enter the default security code: 827827 (or TAPTAP)
3.
Program the Primary Phone Number to dial:
For dialing a number on a POTS or PSTN telephone line (i.e. calling an outside phone number),
use the 10-digit phone number (i.e. 1 + area code + 7-digit number) of the answering point as
the phone number.
4.
Program the Second Phone Number (optional, for when the primary phone number is busy or
does not answer) to dial: [0-20 digits for phone number] # 01
5.
Set the call length, silence time out, ring count, and dial next number on busy: 294521 # 18
See Section 6.8, Timing/Dialing Codes, p.15 for further details.
6.
Recording a Location Message:
1. Record the location message for the ETP-120 Series Call Station in question: * 4
Wait for the tone to begin speaking/recording. The recorded message has a maximum length
of 16 seconds.
2. Press any key to stop recording or it will end after 16 seconds. The recorded message will
automatically play back.
3. To review the recorded message again, press: * 5
4. To delete the recorded message, press: * 3
7.
To exit programming and disconnect, press: # 7
Page 10 of 27
Copyright 2021 Talk-A-Phone, LLC • 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • info@talkaphone.com • www.talkaphone.com.
All prices and specifications are subject to change without notice. Talk-A-Phone, Talkaphone, bAlert, Scream Alert, WEBS, and WEBS Contact are registered trademarks of Talk-A-Phone,
LLC. All rights reserved. All other trademarks mentioned in this document or website are the property of their respective owners and does not imply or indicate any approval, endorsement,
sponsorship, or affiliation with such owners unless such approval, endorsement, sponsorship, or affiliation is expressly indicated.
ETP-120 Series Phone
Installation & Operation Manual
[0-20 digits for phone number] # 00
Rev. 7/2/2021
Advertisement
Table of Contents
