Accessing Programming Mode - Talk-a-Phone ETP-120 Series Installation & Operation Manual

Accessing Programming Mode

The ETP-120 Series Call Station can be programmed from a standard touch-tone telephone through an
analog PBX extension or an analog PSTN line.
It is essential to program at least one telephone number for the Talkaphone unit to operate.
After entering the access code, the order in which codes are entered is irrelevant.
NOTE:
After each programming code, a double-beep indicates the code has been accepted. Four (4) beeps
indicate an error—re-enter the code again.
1. Using the Security Code
1. Mode Configuration DIP Switch #2 is configured at the factory to be in the ON position—
this configures the call station to answer incoming calls. Move to the ON position if that is not
the case.
2. Call into the ETP-120 Series Call Station.
3. Enter the default security code:
4. The call station will output a double-beep and enter programming mode—any programming
code(s) may now be entered. See Section 6.4, p.13 for a comprehensive list of
programming codes.
5. When programming is completed, enter this code to disconnect:
2. Without Using the Security Code
1. Mode Configuration DIP Switch #2 is configured at the factory to be in the ON position—
this configures the call station to answer incoming calls. Move to the ON position if that is not
the case.
2. Move Mode Configuration DIP Switch #3 to the OFF position—this configures the call
station to answer incoming calls and automatically enter programming mode without the
security code.
3. Call into the ETP-120 Series Call Station.
4. When the call station answers, it will output a double-beep and automatically enter
programming mode—any programming code(s) may now be entered. See Section 6.4, p.13
for a comprehensive list of programming codes.
5. When programming is completed, enter this code to disconnect:
6. Finally, return Mode Configuration DIP Switch #3 to the ON position.
NOTE:
If Mode Configuration DIP Switch #3 is not returned to the ON position, activating the pushbutton
will call Talkaphone Technical Support instead of the programmed phone number(s).
Page 11 of 27
Copyright 2021 Talk-A-Phone, LLC • 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • info@talkaphone.com • www.talkaphone.com.
All prices and specifications are subject to change without notice. Talk-A-Phone, Talkaphone, bAlert, Scream Alert, WEBS, and WEBS Contact are registered trademarks of Talk-A-Phone,
LLC. All rights reserved. All other trademarks mentioned in this document or website are the property of their respective owners and does not imply or indicate any approval, endorsement,
sponsorship, or affiliation with such owners unless such approval, endorsement, sponsorship, or affiliation is expressly indicated.
Installation & Operation Manual
827827 (or TAPTAP)
ETP-120 Series Phone
# 7
# 7
Rev. 7/2/2021