Table of Contents
Advertisement
R
C
ACKMOUNT
ONTROLLER
Safety Summary
This section describes safety information for the system. These are recommended precautions
that personnel must understand and apply throughout installation, operation, maintenance, and
troubleshooting. Be sure to read and understand the entire manual before performing any
procedure outlined in this manual. Contact Will-Burt UK with any questions before performing
any procedure outlined in this manual.
Signal Word Definitions
Warnings highlight an essential operating or maintenance procedure, practice, condition,
statement, etc., which, if not strictly observed, could result in injury to, or death of, personnel or
long-term health hazards.
Cautions highlight an essential operating or maintenance procedure, practice, condition,
statement, etc., which, if not strictly observed, could result in damage to, or destruction of,
equipment or loss of mission effectiveness.
Note: Notes highlight an essential operating or maintenance procedure, condition, or statement.
General Safety Instructions
The following are general safety precautions that are not related to any specific procedures.
These are recommended precautions that personnel must understand and apply throughout
installation, operation, transportation, maintenance, storage, and troubleshooting. Additional
precautions that apply to specific procedures and steps may be listed with the procedure or step
to which they apply.
Electrocution Hazard! Contact with high voltage will result in death or serious injury. Observe
general safety precautions for handling equipment using high voltage. Do not locate or operate
mast near electrical lines, cables or other unwanted sources of electricity. Be sure to allow
sufficient clearance on all sides of the mast to allow for side sway. Do not operate mast in
lightning. Be certain electrical cables are undamaged and properly terminated. Always
disconnect power before performing service, repair or test operations.
Shock Hazard! Hazardous voltages are present in this equipment and may also be present in
any associated items. Observe general safety precautions for handling equipment using high
voltage. Always disconnect power before performing repair or test operations. Contact with high
voltage will result in death or serious injury.
Resuscitation! Personnel working with or near high voltages should be familiar with modern
methods of resuscitation. Such information may be obtained from the Bureau of Medicine and
Surgery.
PM-01005-REV 2
Original Instructions
v
May 2021
Advertisement
Table of Contents
