Table of Contents
Advertisement
Section 3
This section describes the operation of the system. Use care to follow all precautions while
operating.
3.1 Pre-Operation Check
Before operating the system, ensure:
•
That all appropriate precautions from the operator's manual (Section 1.3) are followed.
•
Ensure that the following warnings are understood and followed:
Safety Instruction – Installation! Ensure all aspects of the installation have been carried out
correctly and are safe before attempting to operate the system.
Safety Instruction – Operation!
make sure it is safe to do so.
3.2 Switching on the System
The illuminated Power Switch (Figure 3-1) on the front panel of the Rackmount controller turns
power on for both the Rackmount Controller and the positioner.
Once switched on, wait for (10) seconds before attempting any control inputs. This will allow the
system to fully initialize.
Power down the Rackmount controller system when the vehicle is in motion.
Power
Switch
PM-01005-REV 2
May 2021
Operation
Before moving the positioner, the operator must first
Figure 3-1 Power Switch
Original Instructions
R
C
ACKMOUNT
ONTROLLER
3-1
Advertisement
Table of Contents
