Digital Discrete Outputs; Lcd Display - Home Screen; Positioner Address; Figure 3-8 Home Screen - Lcd Display - Will Burt PositionIt PI-75 Operator's Manual

R C
ACKMOUNT ONTROLLER

3.8 Digital Discrete Outputs

The Rackmount Controller is equipped with a series of digital discrete outputs. The digital
discrete outputs can be used to verify the positioner is in the stow position (see Section 3.7), for
interlock purposes (see Section 3.7) or to control third party equipment (typically by
incorporating relays). The digital discrete outputs can be control via Pelco D Auxiliary
commands (see Table 3-1) or through the push-button controls when then the Positioner/Aux
Switch is in the "Aux" position (see Section 3.6).
3.9 LCD Display – Home Screen
The Home Screen on the LCD displays various positioner information which gives the user real-
time positioner feedback. See the following section for more details on the information provided
on the Home Screen.

Figure 3-8 Home Screen - LCD Display

3.9.1 Positioner Address

The Positioner Address displays the address of the active positioner. The positioner address
can be changed in the Selector Menu (See Section 3.10.1).
Note: The Rackmount Controller cannot set or assign an address to a positioner.
3-6 Original Instructions PM-01005-REV 2
May 2021