R
C
ACKMOUNT
ONTROLLER
3.3 Push-Button Control
The positioner system can be manually driven using the (4) arrowed buttons labelled Pan and
Tilt on the front panel. These are momentary push-button controls. To control the positioner,
push and hold the related direction button and release when the desired position is reached.
When using the push-button controls or digital discrete inputs to drive the positioner the
movement speed ramps up to max speed over 2 seconds. Use quick momentary button presses
to achieve accurate small incremental movements.
The push-button controls also control a series of discrete outputs on the 9-pin terminal block
connector on the back of the rack mount controller when the Positioner/Auxiliary Switch is in the
"Aux" position. See Section 3.6 for details on the Positioner/Auxiliary Switch.
Pan and Tilt
Push-Buttons
Figure 3-2 Push-Button Controls
3-2
Original Instructions
PM-01005-REV 2
May 2021