Components; Unpacking; Power And Controls System Overview - Will Burt PositionIt PI-75 Operator's Manual

2.3 Components

The following items are included in the package:
•
PositionIt Rackmount Controller
•
Mains Lead – IEC connector to wall socket
•
(2) Fuse's
•
Hardware Pack (for mounting Rackmount Controller)
•
Power/Data Output (Circular) Connector
•
(3) Terminal block connectors
•
User Manual
•
QA Documentation
It is important that you retain all these items for future use and reference, even if they are not
used in the initial installation.

2.4 Unpacking

Unpack as follows:
1. Carefully open the box(es) and unpack all components
2. Check for any damage from shipping. If damage has occurred, notify the carrier.

2.5 Power and Controls System Overview

This section provides a typical overview of a standard positioner system setup using a
Rackmount Controller. The example provided is for systems with 100-240VAC supplied power
(to the Rackmount Controller) and 24VDC Positioner (standard). Before setting up your system
verify the voltage of your positioner(s) by checking the serial tag located on the positioner. If you
are unsure of your positioners voltage rating contact Will-Burt customer service.
Electrocution Hazard! Do not touch live wires. Make sure all power has been disconnected
prior to performing installation or maintenance. Make certain that the area is free of overhead
power lines and other unwanted sources of electricity. Do not operate the system during an
electrical storm. Follow OSHA safety regulations when working near energized power lines. Be
sure to allow sufficient clearance on all sides of the mast to allow for side sway. Death or
serious injury could result if proper precautions are not performed.
Shock Hazard! Hazardous voltages are present in this equipment and may also be present in
any associated items. Observe general safety precautions for handling equipment using high
voltage. Always disconnect power before performing repair or test operations. Contact with high
voltage will result in death or serious injury.
PM-01005-REV 2
May 2021
Original Instructions
R C
ACKMOUNT ONTROLLER
2-3