Table of Contents
Advertisement
8. Manual Test
Before programming, perform a manual test at first to debug whether the machine can work normally.
(1) Feeder No.1-No.53: after loading tape reel on feeder, click the feeder to test its feeding function.
(2) Alarm light: click this button to test if the light could work correctly, the color should change from red, green to yellow
by sequence.
(3) Buzzer: click this button, the buzzer beeps.
(4) XY initialize: click this button to have XY back to zero.
(5) XY Move: it's to move to a specified position or get the current coordinate. Click this button to enter a vision interface.
The movement modes are optional. Use the crosshair on the left vision interface to move the placement head.
(6) Front IC Camera: it's to test the photograph function.Click this button, front IC camera will take a photo and the image
above front IC camera will be displayed.
(7) Right Mark Camera,Left Mark Camera: it's to test the photograph function. Click this button,the corresponding mark
camera will take a photo and the image below the corresponding mark camera will be displayed.
(8) Head initialize: head initialization can be executed before mounting.
(9) Nozzle Height Calib: it's to adjust the height of the nozzles to the same height. Adjustment method: 1.Preparation tools:
1pc of A4 paper, 1pc of standard nozzle. Steps: 1.Visually confirm whether there is a nozzle on the placement head, click
"nozzle height calib"; 2.Lock the nozzle position to above the track(after selecting the position and nozzle No.1's alignment
method, save it). Select the corresponding nozzle and click the up button and down button on the keyboard to to adjust the
height of nozzle to make sure that the nozzle just presses on the upper plane of the track after the nozzle is lowered. After
34
Zhejiang Neoden Technology Co., Ltd
Advertisement
Table of Contents
