Pcb Information; Backward - NeoDen NeoDen9 User Manual

list interface displays new files, the operation is successful.

2.1 PCB information

In manual programming, this item is the primary editing item, as shown in the figure:
2.1.1 PCB Forward Setting
 Mag Fixture
Select "Mag Fixture" mode, click "Forward" to feed PCB into the mounting position.
 Track
Select "Track" mode, put PCB at the track entrance position and click "Forward", it will be fed into the stop pin position
(this position can be adjusted manually). Once pcb was stopped, the cylinder will raise pcb and pin return back.

2.1.2 Backward

Click "Backward", cylinder will descend and pcb be transit to the end of track, it will stop above the sensor position. If
there's SMT conveyor connected and release signal to pnp machine, pcb will be automatically transit into SMT conveyor.
12
Zhejiang Neoden Technology Co., Ltd