Feeder Setting - NeoDen NeoDen9 User Manual

Batch setting for pick position: please select one stack to start setting (default start from the first assigned stack), at the same
time, a real-time image will be showed as right side. Please adjust the red cross to the 1st component's center ( generally if
the feeder is in off condition, red cross will be at the edge of feeder's tape cover ), click "save and next" until all are set up.
There will be beep sound as a warning, then click "save and exit" will be OK.
While setting the pick position, the function of "Feeder open"/ "Feeder close" can help to set the cross's position more
conveniently.

5.2 Feeder setting

For feeder NO.1-53, the default settings are grey and inactive. Select a feeder, click "Apply" to active the settings, such as
feeder exchange, feeder, nozzle, IC tray feeder etc.
The setting sequence is: Feeder (or IC tray feeder)→ Feeder basic information→ Nozzle.
（1）IC tray feeder info
It is used to set tray package component's pick position.
Right top XY: it refers to align the farthest component on the tray (generally take the component at right top as the

final one on the tray, and take the component at left bottom position as the first one)
X qty: it refers to how many components in X direction

Y qty: it refers to how many components in Y direction

Start X, Start Y: It refers to the first IC in X/Y direction if the tray is in full package; If some ICs have been used whic

h cause the tray is not full, you can directly set the exact position as actual situation, start X will be the location of its a
27
Zhejiang Neoden Technology Co., Ltd